UNIX ON-LINE Man Pages - Die Onlinehilfe

Die Syntax von Unixbefehlen wird in den entsprechenden Manpages dokumentiert. Hier können Sie diese Onlinehilfe für viele Standardbefehle abrufen.

Seiten auflisten, welche beginnen mit:
A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z   ALPHA   NUM   ANDERE   ALLE
BDFLUSH(2)                 Linux Programmer's Manual                BDFLUSH(2)

       bdflush - start, flush, or tune buffer-dirty-flush daemon

       #include <sys/kdaemon.h>

       int bdflush(int func, long *address);
       int bdflush(int func, long data);

       bdflush()  starts,  flushes,  or  tunes  the buffer-dirty-flush daemon.
       Only a privileged process (one with the CAP_SYS_ADMIN  capability)  may
       call bdflush().

       If  func  is  negative  or  0,  and  no  daemon  has been started, then
       bdflush() enters the daemon code and never returns.

       If func is 1, some dirty buffers are written to disk.

       If func is 2 or more and is even (low bit is 0), then  address  is  the
       address of a long word, and the tuning parameter numbered (func-2)/2 is
       returned to the caller in that address.

       If func is 3 or more and is odd (low bit is 1), then  data  is  a  long
       word,  and the kernel sets tuning parameter numbered (func-3)/2 to that

       The set of parameters, their values, and their valid ranges are defined
       in the kernel source file fs/buffer.c.

       If  func is negative or 0 and the daemon successfully starts, bdflush()
       never returns.  Otherwise, the return value is 0 on success and  -1  on
       failure, with errno set to indicate the error.

       EBUSY  An  attempt was made to enter the daemon code after another pro-
              cess has already entered.

       EFAULT address points outside your accessible address space.

       EINVAL An attempt was made to read or write an invalid  parameter  num-
              ber, or to write an invalid value to a parameter.

       EPERM  Caller does not have the CAP_SYS_ADMIN capability.

       bdflush() is Linux-specific and should not be used in programs intended
       to be portable.

       fsync(2), sync(2), sync(8), update(8)

       This page is part of release 3.25 of the Linux  man-pages  project.   A
       description  of  the project, and information about reporting bugs, can
       be found at http://www.kernel.org/doc/man-pages/.

Linux                             2004-06-17                        BDFLUSH(2)

Scannen Sie den Barcode um die Webseite zu öffnen

Quelle: http://www.trinler.net/de/service/doc/linux/man.html?command=bdflush
Gedruckt am: 13.12.2017 12:10 GMT+0100 (2017-12-13T12:10:44+01:00)